Door Closer Problems: Adjust, Repair or Replace?

Key points

  • Most closer problems are adjustments, not failures.
  • Oil on the closer or the door means the closer has failed and has to be replaced.
  • On a fire door, a working closer is a requirement. The door has to close and latch by itself.

The door closer does more work than any other piece of hardware on a commercial door, and it is the one most often blamed when a door misbehaves. Many closer complaints can be fixed with a screwdriver in a few minutes. Some cannot. This guide explains how to tell the difference.

Commercial door closers

What a closer controls

A closer is a spring and a hydraulic cylinder. The spring closes the door, and the fluid controls how fast. Most commercial closers have separate adjustments:

  • Sweep speed: how fast the door moves through most of its swing.
  • Latch speed: how fast it moves over the last few degrees, where it has to overcome the latch.
  • Backcheck: resistance near the fully open position, which stops the door being thrown against the wall.
  • Spring power: how much force the closer applies, matched to the size and weight of the door.
  • Delayed action: on some models, a pause before the door starts to close.
Surface-mounted door closer on a commercial door
A surface-mounted closer, the most common type on commercial doors.
Surface door closer with a parallel arm
The same type of closer fitted with a parallel arm.

Common problems and their causes

What you seeLikely causeUsual fix
Door slams shutSweep or latch speed set too fast, or fluid has leaked outAdjust. Replace if leaking.
Door closes but does not latchLatch speed too slow, spring power too low, or air pressure in the building holding the door off the latchAdjust latch speed and spring power
Door is hard to push openSpring power set higher than the door needsReduce spring power, within what the door needs to close
Door swings open and hits the wallBackcheck set too light or not workingAdjust backcheck. Add a stop if needed.
Oil on the closer body or the doorSeal has failedReplace the closer
Closer will not hold its adjustmentInternal wear or loss of fluidReplace the closer
Arm is loose, bent or noisyFasteners have worked loose, or the arm has been forcedTighten or replace the arm
Door closes at different speeds in winter and summerFluid thickens in cold weather, common on exterior doorsSeasonal adjustment

When a closer has to be replaced

  • It is leaking oil. A closer cannot be refilled in place.
  • It no longer responds to adjustment.
  • The body is cracked or the arm mounting is torn out of the door or frame.
  • It is the wrong size for the door. An undersized closer on a heavy or wind-exposed door will fail early however it is adjusted.

When a closer is replaced, the new one should be matched to the door: its width and weight, whether it is an interior or exterior door, and how much traffic it carries.

Corroded floor closer with the cover plate removed
A floor closer with its cover plate removed. Corrosion like this cannot be adjusted out.

Closers on fire doors

A fire door has to close and latch by itself every time. That makes the closer part of the fire protection of the building, not a convenience. A closer that has been disconnected, a door that is propped open, or a closer too weak to latch the door are all deficiencies in a fire door inspection. A replacement closer on a fire door has to be one that is listed for that use.

Closers and accessibility

Building codes limit how much force a person should need to open a door on an accessible route. A closer set too strong can put a door outside that limit, so spring power is a balance: enough to close and latch the door, and no more. Where a door cannot meet both needs, an automatic operator is the usual answer.

A closer that keeps failing

If the same door goes through closers, the closer is rarely the real problem. Look for a door that is binding in its frame, hinges that have dropped, wind or building air pressure working against the door, or people forcing it. Fix the cause and the closer will last.

For closer adjustment, repair and replacement, see commercial door hardware and commercial door service.